-
Hi Boris,
Appreciate all the work you do. In 2.5.3, after a successful flight and coming in to land in essentially a hover, the quad flipped upside down and went full throttle in to the ground. I fig…
-
Occationally when using a multi protocol module I notice and issue in which the protocol does not change when swapping between two multi protocol module aircraft.
eg. Flysky & DSMX
The solution…
-
have tried
Flashing the receiver with 27ms Firmware. d4r-ii
Re-flashing the controller with the same firmware using DFU (1.12RC2)
Setting failsafe on TX.
Resetting RX
If oneshot is disabled, then t…
-
I have a PixHawk Board with PX4 Firmware flashed on to it via QGroundControl.
**Frame:-** S550 Hex
**Gimbal:**- Tarot T-3D - III
**Flight Controller :-**PixHawk 2.4.8
**Transmitter**:-Flysky FS-…
-
Some Pixracer users are reporting that AC3.4 is not accepting PPM input, in particular with the FlySky FS-i6s transmitter/receiver.
Report here: http://discuss.ardupilot.org/t/copter-3-4-has-been-r…
-
Hi! I don't know if this is an "issue". If not, please don't hesitate to close this.
I think that now that Cleanflight is based in betaflight, some FC have loose functionalities, like GPS or iBus T…
-
Hi,
I was wondering if anyone knows how to dump the existing firmware? Is it possible via serial UART or would you need a JTAG programmer?
Thanks!
-
When using the multi protocol module with the flysky protocol..
You cannot set the max channel numbers transmitted. Its fixed at 12ch (if I remember from tests yesterday)
This can cause issues …
-
Hello, trimming acc via stick command reset the FC just after moving right stick without save the new settings.
-
INAV 1.7.3 on SP Racing F3 in a FPV Racer quadcopter; PWM RX; UBlox GPS
RTH works fine when activated over remote.
Failsave set to RTH.
--> Switch off remote. Motors immerdiately off and copter …