-
Hello, how to use spindle-PWM signal in Ramps 1.4 and Arduino mega ?
i want to use Servomotor in spindle-PWM signal pins, now iam using " grbl mega 5X" firmware,
I’ve been through the config.h s…
-
I would like to use a manual pulse generator (encoder) with my keypad. Is there some documentation on how to use MPG_MODE? I have uncommented that in my_machine.h. What happens when I send 0x8B with a…
-
### Controller Board
6-pack
### Machine Description
ESP32 Dev V1 Board 30 pin. 6 axis cnc card
using 6 axis card .
### Input Circuits
```yaml
Iputs are xyzabc home limits and overtravel limi…
-
### Wiki Search Terms
Install web ui
### Controller Board
MKS DLC32 v2.1
### Machine Description
testing machine
### Input Circuits
_No response_
### Configuration file
```yaml
board: MKS-D…
-
### Version
2.0.7
### Hardware / Firmware
GRBL 0.9
### What happened
when i just try to connect the machine with the icon above a notification shows below it says error while processing response …
-
**Describe the bug**
Cannot print from SD card attached to ESP32-CAM.
I can upload a GCODE file to microSD (cumbersome).
But then, when I click the Play button, all I get is:
```
M23 /For…
-
In the jog rose the movement of the axes is reversed compared to the GRBL configuration.
Movement works fine under Lightburn/LaserGRBL and TS35 monitor.
-
I encountered an issue today when I enacted a **FEED HOLD** and a subsequent **HALT** in the middle of the exectution of a canned cycle. Motion occurs after **HALT** is enacted.
The below g-code mo…
-
I've checked 3 machines here with fairly recent versions of ioSender (inlcuding most recent edge version and 2.0.36 release) and none of them are showing any Grbl settings descriptions.
Going back …
-
Hi. Its the V2 board that I can find only very little information online regarding this board.
Yes its quite a new board.
What I have found is :- https://github.com/makerbase-mks/MKS-DLC32/blob/ma…