-
Most 3d printer is using the bed mesh leveling with the ONE probe, feel it is very slow. Can klipper do two probes or multiple probes at the same time for 4-point bed mesh leveling?
-
I user BED_MESH_PROFILE LOAD=PEIK
Error reported by printer:
Your printer's firmware reported an error. Due to that OctoPrint will disconnect. Reported error:
bed_mesh: Unknown profile [PEIK]
[p…
-
Hi!
I just received my SKR mini E3 V2.0 and i'm trying to install it.
did a git pull, make menuconfig, make clean, make, copied the bin to a microsd, it flashed.
checked the microsd, fimware.cur…
-
After the update, it issues:
"mcu 'rpi': Command format mismatch: config is_config=%c crc=%u is_shutdown=%c move_count=%hu vs config is_config=%c crc=%u move_count=%hu is_shutdown=%c
This type …
-
Hi there, could someone add default buzzer support to printer-creality-ender3pro-2020.cfg and V2? I just dont know the pin number
-
**Describe the bug:**\
The bed mesh / Heightmap view of Mainsail allows renaming the active profile and loading existing profiles from the configuration, but as soon as the profile contains a space (…
-
Hello,
since I upgraded in Mid August, I have a reapeated bug which leads to destroyed beds and emergency shut offs.
**Problem:**
After a successful print is finished, on the next print the n…
-
`mcu 'mcu': Unable to encode: config_spi
This type of error is frequently caused by running an older
version of the firmware on the micro-controller (fix by
recompiling and flashing the firmware)…
-
Need some help configuring my Ender 5 with Klipper. I'm using the SKR Mini E3 board along the EZABL Pro probe. and cant get homing to work correctly. when trying to home the Z moves up a little, the X…
-
After printing the hot end sits on the top of the printed part due to a failure to home. I would say 95% of this happens. Every so often it will home correctly.
If I run **G28 X** by hand from the …