-
> @JLefebvre55
**Completion is tracked in the linked PR.**
## Design Scope
Design a solution dosage system for the addition of pH balancing solutions and nutrient solutions.
### Purpose
…
-
The VCU and BMS run on the same hardware design. There is no reason not to configure all hardware upfront and never worry about configuration again until a new design is made
- [x] Run 1227 code on…
-
I would love to have some alternatives for the atlas scientific digital pumps.
they just updated the price down to $35 !
Plus they're getting only 5V, directly via I2c .. which makes the wiring so…
-
Would be cool if the firmware shut the output off if overcurrent is detected, like the standard shelly does.
-
I have a handful of 64x64 panels with ICN2037 LED drivers (along with ICN2012's) and each panel draws about 100mA @5V when not clocking in any data to them (even when explicitly pulling the OE high an…
-
**Describe the bug**
`GPIO6`, the `BATT_EN` is always `0V` and the MOSFET `Q1` is never turned ON.
**To Reproduce**
Steps to reproduce the behavior:
1. Ensure the bodge is applied #5
2. …
-
Hey everyone! First time contributor but long time fan of the project! I have been developing a handful of features on my own fork that suit my own personal workflow and general enhancements that I w…
-
I'll post here since it's related only to powermon.
I setup powermon as a service to report Daly BMS data. I works fine most of the time. I noticed after running it for about 22-24 hours I get empt…
-
Hello!
Are [IRF3708](https://www.infineon.com/cms/en/product/power/mosfet/n-channel/irf3708/) and [NDP6020P](https://www.onsemi.com/pdf/datasheet/ndp6020p-d.pdf) a good replacement for BS270 and BS…
-
Looking over the schematic, it appears there's an unlabled 8 pin part. does there happen to be a part number on the chip?
![image](https://user-images.githubusercontent.com/418929/131994636-165d0cca-…