-
Exception in thread Thread-4:
Traceback (most recent call last):
File "/usr/lib/…
-
I follow the instructions with the pre-build HW (dpu.bit dpu.hwh, dpu.xclbin) on ZCU104; it implements successfully.
And I follow the Rebuild instructions to generate my own HW (dpu.bit dpu.hwh, dp…
-
https://github.com/Xilinx/PYNQ/blob/3f634506e4d428cb07bb5a57c1d95cab0c803d20/pynq/buffer.py#L127
I believe it should call `freebuffer()` not `free_buffer()` this causes
`AttributeError: 'PynqBuf…
-
**Description**
I'm trying to build GHDL from source on the Raspberry Pi 4 (Linux raspberrypi 5.4.51-v7l+ #1333 SMP Mon Aug 10 16:51:40 BST 2020 armv7l GNU/Linux), however I'm getting errors during t…
-
Thank you for such an amazing project. I am quite new to this but I think. the tcl file is not supported in PYNQ anymore. So i need to build the project again. I already have exported the IPs using yo…
-
Hello,
when I run the script on Raspberry Pi Compute Module 4 rev 1.0, i am getting a "Board not supported" error message.
Here are the info from detect.py:
Chip id: BCM2XXX
Board id: None
…
-
This page:
[https://pynq.readthedocs.io/en/v1.3/17_appendix.html#writing-the-sd-card-image](https://pynq.readthedocs.io/en/v1.3/17_appendix.html#writing-the-sd-card-image)
outlines a process on a Ma…
-
Newer ROS versions recommend Ubuntu 20, so with this image we are stuck with older releases.
-
Has the CLA gone walkies? It just shows a blank page
https://www.clahub.com/agreements/Xilinx/PYNQ
-
is there any way by which we can access power rails via pynq pmbus in ultra96 v2. I would like to know if it is possible to measure power via pmbus without flashing the board to v2.6 image?