-
I have been using SBUS no problems for a long while now but needed to switch to PPM due to current limitations with the TBS Crossfire.
I am unable to get any recognised PPM signal on the RC IN port…
-
A few weeks ago I had a FW model configured with `failsafe_procedure = RTH` go out of range and it failed to do return. Unfortunately, my spotter couldn't see the model and I lost video too because Lo…
-
INAV 1.7.3 on SP Racing F3 in a FPV Racer quadcopter; PWM RX; UBlox GPS
RTH works fine when activated over remote.
Failsave set to RTH.
--> Switch off remote. Motors immerdiately off and copter …
-
I'm running INAV 1.5.1 NAZE on F450 Multicopter with the configuration below.
I was alerted by a youtube user (iforce2d) that uploaded this video to his channel:
https://www.youtube.com/watch?v…
-
---- Minecraft Crash Report ----
WARNING: coremods are present:
MalisisCorePlugin (malisiscore-1.12.2-6.4.0.jar)
DynamicSurroundingsCore (DynamicSurroundings-1.12.2-3.4.9.13.jar)
Inventory…
-
Three different cloned omnibus f4 pro boards all with the same issue.
General airplane config
I've tried all versions of omnibus f4 pro firmware.
All radio channels show correct movements in …
-
When trying to arm the motor using the RC transmitter I get the following error message: 'Unable to arm due to error code 2', This is the IMU not responding error code, but I can calibrate and receive…
-
I bought a "HGLRC F3 V3.1" flight controller because I have made good experiences and many flights with iNav from version 1.5 to now on different boards (naze32, sp racing f3, Omnibus F3) and flying w…
-
The generated "inav_1.7.3_OMNIBUS.hex" seems to be ok until gps AND airplane is activated. When gps AND airplane is selected the communication with the board is no longer possible. ->"Waiting for dat…
-
Hi!
I am trying to run the dev build of peertube through `npm run dev` command but cannot figure how to make it works. I have `[nodemon] Internal watch failed: watch /home/sephir/dev/js/PeerTube/di…