-
Hi, I try to generate a map in a 170m x 50m area. I turned off the global SLAM first by `POSE_GRAPH.optimize_every_n_nodes = 0`, and the result is ok for a system without global optimization.
![path…
-
I have a RPi4 with Raspian Buster running Rtkbase 2.2.0. It is plugged into a UBlox F9P, specifically the C099-F9P Application board. Raspbian is fully updated.
When I plug the ublox into my Windo…
-
## Current Behavior
My set-up:
- Jumper T16 (latest OpenTx)
- R9M module (older pre-2019 model, latest firmware)
- Many R9 Slim+ receivers (older pre-2019 model, latest firmware)
- 4 x Matek F4…
-
This looks like a good quality, rightly priced F4 AIO FC + 4-in-1 ESC stack.
https://www.diatoneusa.com/store/p587/MAMBA_F405_Betaflight_Flight_Controller_F40_40A_3-6S_DSHOT600_FPV_Racing_Brushless…
-
Det er satt opp et møte fredag 19. februar 2020 - 10.00 til 11.00, om hvordan løse forhøyet dagpengesats til de som har vedtak fra før 20.mars 2020.
Sendt innkalling til alle utviklerne, så bestemm…
-
Ok, so I'm here (for the first time) after my Tabs Below the Nav Bar and Bookmark Bar userChrome code has apparently been broken again by the most recent Nightly. 20181106
I've tried yours, and if…
-
**What did you expect to happen?**
C-a to not jump lines and remain in the same line.
**What actually happened?**
C-a jumps to the previous line on which the command (C-a) was called
**Addit…
-
**What did you expect to happen?**
- I've enabled `multiple-cursors`
- If the cursor is a single word and I use the shortcut 'M-d' repeatedly, all existing words should be selected one after the oth…
p1tt1 updated
3 years ago
-
**What did you expect to happen?**
I expect the mu4e buffers to have font-lock mode enabled. I expect to see this:
**What actually happened?**
When I open mu4e, I see this instead:
**A…
-
**Describe the issue**
`bin/doom re` hangs for a long time, then fails for some of the packages.
End of output:
```
.
.
.
! A thread has timed out. The following packages were skipped…