-
## The problem
The deCONZ addon seems to randomly stop itself without warning. It can be started again normally and work just fine, but then will stop again some indeterminate time later. It's ha…
-
Hey @visualapproach,
Want to get some clarification around some stuff and also share a somewhat success story.
We have. managed to get this solution working on the model Maldives 54173 (2019) - …
-
The latest RC has been around for two months. Since few changes are occurring, and the whole purpose was to "RELEASE the part that works rather than waiting for everything to get fixed", perhaps we ne…
-
I'm using Klipper on a Due/RADDS configuration and very happy with everything so far, except the fact I can only use the serial ports connected to the USB connectors, and not the UARTs that breakout o…
-
Firstly @NigelCoxon can I thank you for taking the time to create this; it works a treat on integrating our decade-old PRT network into HA via an RS485 converter, unlike the built-in integration!
M…
-
Hello, i'm having An issue when i upload Marlin 2 to my Skr2.0 revB with 2209 stepper drivers. Printer is a tronxy x5s corexy model. I can move all Axis, however X and Y only move diagonally. Corexy …
-
### The problem
Im getting error on a Node. This is a heatit thermostat.
### What version of Home Assistant Core has the issue?
2022.01.03
### What was the last working version of Home Ass…
-
```
The Marlin version RC7 - 31 Jul 2016
Machine Self build coreXY
Electronics board ramps 1.4 with arduino 2560
Machine components (direct drive e3d lite, with termistors (my stepper drivers are m542…
-
# The current state
Using "switch" provide torn syntax, reuse parent scope, may process part cases.
# Problem statement
Source code with "switch" provide simple case processing.
# Proposal…
-
I just upgraded to the latest dev version. I noticed one change that broke my init G-code.
I had the following:
G28
G1 Z10.0 F{travel_speed} ;move the platform down 10mm
G29
Now, with the new v…