-
I'm getting this when trying to unclock ECU. result is the same with v0.6.0 and v0.5.4
Using tactrix (genuie). But i'm unsure if i need to install anything else from your windows downloads?
![…
-
Hello Daniel,
I like to have a little change in the serialize method of elements:
For sub elements (and nested) of the element, the serialize method was called, identifiable elements shall be i…
-
timing is set to 10 degrees fixed in tunerstudio
which means the two lines should overlap (PIP - Crank wheel/blue signal and SPOUT - output to ignition box/orange signal)
but it drifts like 27 degre…
-
Rate-of-return/deltaRPM based enable for idle logic, i.e. RPMs falling faster than X/second
If RPM is headed toward idle quickly, enter idle before we actually get there. Can help avoid stalling be…
-
Hello, I am trying to use the CANBus Monitor. I am able to successfully receive message on the CAN but while transmitting I am facing the below error as shown in the screenshot.
twai_transmit Fail E…
-
I trying to send a payload 0x10 0x01 to an ECU under CANFD ISO 15765-2 2016 and TX_DL as 64, we'd expect the can frame should be 0x00 0x02 0x10 x01 ..., but the library will still package the payload …
lhrbu updated
1 month ago
-
problem statement: initial setup
contributing factor: warnings are invisible
solution: fatal errors have great visibility with clear text
nuace: we do not want to fatal while in the corner at th…
-
Hello Everyone,
A few months ago I created a code generation project named cantata (https://github.com/polfeliu/cantata), that generates code for ECUs connected to CAN networks according to the spe…
-
I am trying to communicate with the BMS in a battery over RS485 but do not know the protocol details. I tried to load the aia file on Kodular to find out but I get errors loading the blocks when I do …
-
Vic2 to HoI4 did this:
```
warSupport += static_cast(
(warAttitude * 0.375) + (sourceCountry.getRevanchism() / 5.0) - (sourceCountry.getWarExhaustion() / 2.5));
if (warSupport < 15)
{
warSuppo…