-
## Current Behavior
The accelerometer is well calibrated but in the setup tab, the values move while the quad is stationary and no vibrations could disturb it.
I noticed this because when I act…
-
## Current Behavior
If fw_level_pitch_trim is set at a certain value to maintain level flight in self level modes, the AHI will still follow the RAW sensor value. This leads to an AHI offset in level…
-
I'm currently building an old Tsunami F3J (high end RC glider) into a FPV platform. I'm using Matek F405 WMN FC and iNav 7.
Due to physical space issues, the FC cannot be placed with the arrow poin…
-
The Mixer is capping the MAX Motor Command to 85% even when MAX_THROTTLE (etc...) is set to 100%.
You can see in the below two examples when MAX_THROTTLE is set to 2000us (100% throttle --- no CAP)…
-
### Describe the bug
When MAG is enabled, the YAW position shows the same YAW position regardless of the position of the QUAD. When rotating the QUAD yaw position, the setup window shows the quad mo…
-
I'm using FF F35_LIGHTNING FC with iNav 5.1, Skystars Talon32 Slim40 ESC on a Zohd Dart250 wing using Dshot600 protocol. Everything works perfect except ESC Telemetry (RPM, Temp etc). I've already tri…
-
Custom BOB57 with Diatone Mamba H743 mark 4
## Current Behavior
After updating to Inav 7 i noticed some Pitch jerk movement, investigating the RAW gyro signal shows some strange occasional full sc…
-
On the existing Speedybee F405V4 flight controller, there isn't a way to use SmartPort for FrSky receivers with INAV.
Using the resource mapping in Betaflight, it is possible to reassign the LED o…
-
In Mission Control Default Settings can't be saved. Clicking on Save Button does notthing.
Hello sir.
I'm using the MPU9250 and have connected it ove…