-
Hi,
thank you so much for your hard work on Klipper.
My issue is I have changed my thermistor and my heater cartridge and now I am having negative reading on my Sovol SV01.
When I run PID_CALIBR…
-
Since a while i'm thinking about the possibility to make it obsolete to manually calibrate the z-offset by using the combination of a microswitch endstop and bltouch which allows additional the change…
-
since klipper 0.10, the MCU sometimes won't connect to the Pi. I've to shutdown the printer completely, and most of the times it connects in this case. It's really annoying. I've never had this issue …
-
### Fluidd Version
1.19.0
### Browser
Safari
### Device
Laptop
### Operating System
macOS
### What happened
There is no option to turn on the navigation menu power toggle, the only option is …
-
When defining a manual stepper, I get this error:
Error: Option 'rotation_distance' in section 'manual_stepper stepper_a' must be specified
My config specifies `gear_ratio` but not `rotation…
-
Hi, i tryed to install klipper on fedora server 34 and i got many issues
I used install-centos.sh script
first, I have to force installing greenlet cffi and serial with python 2.7, pip for python …
-
## Observed behavior:
```gdb
Receive: 12 71128.353854 71128.346986 18: seq: 15, tmcuart_response oid=0 read='\n\xfa\xef-\xa0*\n( \xe6'
Receive: 13 71128.364091 71128.357921 18: seq: 17, tm…
-
I got error "MCU 'mcu' shutdown: Timer too close" after over 20 hours of printing.
No additional plugins in octoprint. I try to change power supply, usb cable - has no effect. If pring time more…
-
According to https://marlinfw.org/docs/gcode/M204.html, M204 S<accel> has been deprecated. "P<accel>" and/or "T<accel>" should be used.
p-v-n updated
2 years ago
-
**The cause:**
I changed my bed mesh point counts from 9,9 to 5,5 , But forgot to change relative_reference_index from 41 to something sensible and in range for a 5x5
**The problem:**
So far, t…
ghost updated
2 years ago