-
https://www.youtube.com/watch?v=v0Zdn3U-BGg&feature=youtu.be
In ACRO and STB mode, just like video shows, when I change the throttle, the servos will change also. they seems mixed together. I didn't …
-
I have been using SBUS no problems for a long while now but needed to switch to PPM due to current limitations with the TBS Crossfire.
I am unable to get any recognised PPM signal on the RC IN port…
-
A few weeks ago I had a FW model configured with `failsafe_procedure = RTH` go out of range and it failed to do return. Unfortunately, my spotter couldn't see the model and I lost video too because Lo…
-
I bought a "HGLRC F3 V3.1" flight controller because I have made good experiences and many flights with iNav from version 1.5 to now on different boards (naze32, sp racing f3, Omnibus F3) and flying w…
-
---- Minecraft Crash Report ----
WARNING: coremods are present:
MalisisCorePlugin (malisiscore-1.12.2-6.4.0.jar)
DynamicSurroundingsCore (DynamicSurroundings-1.12.2-3.4.9.13.jar)
Inventory…
-
INAV 1.7.3 on SP Racing F3 in a FPV Racer quadcopter; PWM RX; UBlox GPS
RTH works fine when activated over remote.
Failsave set to RTH.
--> Switch off remote. Motors immerdiately off and copter …
-
When trying to arm the motor using the RC transmitter I get the following error message: 'Unable to arm due to error code 2', This is the IMU not responding error code, but I can calibrate and receive…
-
Three different cloned omnibus f4 pro boards all with the same issue.
General airplane config
I've tried all versions of omnibus f4 pro firmware.
All radio channels show correct movements in …
-
### If your issue looks like a hardware fault or a configuration problem please don't raise an issue here.
I have verified with multiple FC, ESC is verified with other firmware. Triflight and betafl…
-
### Board and Version
Omnibus F3 v1.1
_Use CLI command `version` and put its output here_INAV/OMNIBUS 1.7.3 Sep 9 2017 / 10:09:29 (974440df)
### Behavior
* When applying ALThold on my Trico…