-
ok I just found out about this universal g-code sender and I have to say I was pretty happy when I found it. I've been using chilipepper and i don't really like it! What I want to know is why do you h…
-
Hi,
I just purchased a TinyG for a side project at work. I have a 24v 6A power supply, a nema 17 stepper, and a small 12v fan. I connected the power as usual (+ to +, - to ground) and I used a Multi…
-
Hello,
This isn't necessarily an issue, but more of a general question. (If there is somewhere better I can ask questions please let me know.)
I am wondering if I can use the enable/direction/step p…
-
The frontend communicates with serial connected boards via the node server (as middle tier), but with ethernet connected boards the communication is directly between frontend and controller board. Thi…
-
Are there drawing available for the PCB? I was laying out a panel for this board and have already drawn most of it but was starting to add more detail and thought I would check/ask. Did not see anyt…
-
Dear all
I made a test long time ago to run 6-axes from an Arduino Due and after a little bit of fiddling around I got it to work. The version I started to work with at that time was a807727d7 "089.0…
-
I was running a simple contour path and noticed that it sounded like a motor was losing steps right as it went to arc out of the contour. After some investigation, it indeed is losing steps and it doe…
-
Hi, I am looking to create a simple DRO using the TinyG JSON API directly.
I have configured TinyG to send a status report every 100ms using `{si:100}`.
I then issue some GCode:
```
{gc: "g64"}
{gc…
-
1) The software should be tested with the newest TinyG firmware
2) The software should retrieve the firmware number from TinyG and use bug workarounds only if needed or use new features only if suppo…
-
@jorgerobles Are there any controllers which use mm/s for F instead of mm/min?