-
**Printer type** - [MK3.9]
**Printer firmware version** - [5.0.0]
**Original or Custom firmware** - [Original]
**Optional upgrades** - [None]
**USB drive or USB/Octoprint**
USB drive
*…
-
Reproduction Steps:
1) Reboot printer
2) Raise nozzle temperature
3) Observe that servo position in in 'move' and filament locked
3) Issue a toolchange command (my first macro in START_PRINT)
4…
-
Enter what type of printer or upgrade the enhancement applies to.
**Printer type** - MINI
**Optional upgrades** - Filament Runout Sensor
**Is your suggested improvement related to an existing pro…
-
(I have searched for this bug, and not found it)
**Printer type** - MINI+
**Printer firmware version** - 5.1.0-alpha1+12820
**Original or Custom firmware** - Original
**Optional upgrades**…
-
**Printer type** - Mini+
**Printer firmware version** - [4.4.0]
**Original or Custom firmware** - [Original]
**Optional upgrades** - [Filament Runout Sensor]
**USB drive or USB/Octoprint**…
-
Given that this unit is able to detect missed steps could this functionality be adapted to allow for sensorless homing ?
-
I hooked up a filament runout sensor to the toolhead of my SV06, which uses an SKR Mini E3 V3, I'm very sure it's wired correctly.
My printer.cfg has the following:
[filament_switch_sensor filame…
-
**Printer type** - MK3S
**Printer firmware version**- 3.8.1
**Describe the bug**
I'm getting repeated "ghost" y-axis crashes when printing models both from the SD card supplied with the printe…
-
When my delta homes it will stop one or more axes short of the endstop, then does its back off, and on the retest it starts for the endstops again but often (not always) stops short. In the end, some…
-
I really think the coast feature would benefit from a linear deceleration of the print head, rather than a fixed percentage of speed. As the extruder drive stops, flow rate is a function of pressure, …
CCS86 updated
8 years ago