-
When my delta homes it will stop one or more axes short of the endstop, then does its back off, and on the retest it starts for the endstops again but often (not always) stops short. In the end, some…
-
### Question
Activate Relay an boot (no Home Assistant available)
### Additional Details
Hello Edward,
today we talked to other colleagues about the NSpanels and identified the following p…
-
Hello,
Have new problem, do not understand :
2024/01/08 19:56:30 PWS_IP env var undefined
I had uninstall it and try many time no changes.
thanks
regards
nrc04 updated
1 month ago
-
## Description
Say, a freezer set to 275K is going to cool much, MUCH slower than a freezer set to 75K, resulting in fucky usage like setting a freezer to 75K, cooling down whatever to -200C, then …
-
Filament sensor trigger a Pause and the nozzle go to the park position with the heater on, could be possible to add a configurable timer (inside config.ini) to turn off the heater after a long pause ?…
-
For the innovations flex project, the new chart `roof_area_for_pv_in_households` is added to the front-end, which shows the used roof area for solar panels, pvt-panels and solar thermal collectors.
…
-
Hi,
Soft version: 1.23
Station: T420d
Oryginal JBC C115-120.
The temperature jumps at standby between 90-132/139 load from 0-full. When operating at the set 350 degrees Celsius, the temperatur…
-
### System Health details
## System Information
version | core-2024.1.5
-- | --
installation_type | Unknown
dev | false
hassio | false
docker | false
user | root
virtualenv | false
python_…
-
### Checklist
- [X] I have filled out the template to the best of my ability.
- [X] This only contains 1 feature request (if you have multiple feature requests, open one feature request for each feat…
gd360 updated
5 months ago
-
I am running ercf on a custom Delta printer. When a clog is detected, or there is no filament in the cart, I will get a "Move out of range" error when the printer goes into the pause state. I have tri…