-
Hi!
I am trying to run the dev build of peertube through `npm run dev` command but cannot figure how to make it works. I have `[nodemon] Internal watch failed: watch /home/sephir/dev/js/PeerTube/di…
-
The generated "inav_1.7.3_OMNIBUS.hex" seems to be ok until gps AND airplane is activated. When gps AND airplane is selected the communication with the board is no longer possible. ->"Waiting for dat…
-
To make a long story short, I have a TBS G2 frame with TBS Endurance motors and a 4-in-1 ESC (Lumenier BLHeli_S 35A 4-in-1 12v / 5v BEC DSHOT ESC +Current Sensor). In Betaflight 3.2.1 it flew perfectl…
-
#### Issue details
When flying out of RC transmitter signals range and then tried to change flight mode from Auto or RTL to Manual from GCS (Mission planner) via Action tab then Arduplot doesn't chec…
-
then I flash 1.8 and 1.7.3 ，I2C works will
-
The Beeper is not sounding on a NAZE Full Rev.5 with 1.7.3.
After a test flight with 1.7.3 I noticed that the beeper was no longer beeping at all.
To test:
1. Flash and erase NAZE 1.7.2 -> beeps af…
-
hello
a full battery is showing only 0,9V in gui and osd
in betaflight it is 16,5V and it is okay
is it the wrong target i flash? omnibusf4 pro oder omnibusf4v3???
vbat_max_cel…
-
-
When GPS has fixed 6 or more satellites, Complete telemetry is broken. All Data modules freeze and activity light stops blinking. Reproducible with iNav 1.7.3 on SPRacing F3 Deluxe, SPRacing F3 Acro a…
-
Hi
I'm trying to get gps modes working, but it wont enable in modes tab. RTL should enable angle, althold automatically.
I have gps with at least 17 satellites on softserial 2 and it's working fine…