-
I'm having problems decelerating from certain rotational axis moves. The problem manifests as the motor stalling out and missing steps as soon as the moves starts to decelerate. This only occurs for…
-
I am building a PNP that uses TinyG2 for motion control. I am trying to find a couple pins I can toggle on/off a vacuum pump. Worst case I can use the spindle/coolant pins, but wasn't sure if there …
-
Add the "Pause", "Resume" and "Cancel" button function in the "File section" for the TinyG firmware.
I am in the process of switching over to a TinyG controller and just discovered that most of the f…
-
I've had this problem for some time but never got around to diagnosing it.
I am running Windows, and the problem has been verified with different computers.
Symptoms first found with chilipeppr:
¤1 I…
-
I am using http://chilipeppr.com/jarret and expected the below button to redefine the current work coordinate system to make the current tool position equal to zero. (That would be consistent with the…
-
Firmware Edge 446.19
When a limit switch is hit, the TinyG sends out about 50 error messages, but does not flash the
spindle direction LED like in previous versions. After that the TinyG does not res…
-
@chamnit
Right, if I need to write a whole new buffer for SPJS (refer the fight in issue 52 on openhardwarecoza/LaserWeb2), i'd rather start over fresh (In nodejs, where i am comfortable, and withou…
ghost updated
8 years ago
-
Hi All,
Its been a while since we have discussed raster engraving. Currently using smoothieware we can raster engrave around 40mm/s without jittering. This speed is far too slow to make nice raste…
-
Not a high priority as it works, but when I connect to the TinyG, the CPU pops up to 25% on a quad core, 50% on a dual core, even while the system is idle.
Disconnecting drops the CPU down normal leve…
-
can not get chilipeppr running have a red light flashing on the tinyg light spdir on the tinyg keeps flashing. not sure why. is there a way i can reset the tinyg
any suggestions.