-
I want to connect 2 TMC2209 to arduino ,
when i send 1 in serial just one stepper worked wich have address 0b00 the otherone with ADD 0b11 not worked , however MS1 MS2 with Vio for Add 0b11
this…
-
I got a new SKR 3 (not EZ), and after some tests i found out that the Z axis and the extruder aren't working. By some more testing with a spare motor and cable, I determined that the problem is on the…
-
Hey,
I am trying to find the right settings for a Pololu Stepper Motor NEMA 11 Bipolar 200 Steps Rev 28×45mm 4.5V 0.67 A Phase for chopper configuration but even though I calculated the parameters …
-
What does the pins on the driver do? Check these:
* GND
* +5V (Does it provide or need 5V here?)
* DIR (Most likely: 5V HIGH/LOW sets direction)
* STEP (Most likely: short 5V HIGH pulses increme…
-
As discussed during the lecture, here's the link of the board that I've told you about that I was thinking of using with a LEGO.
https://shop.pimoroni.com/products/inventor-2040-w?variant=4005306315…
-
### Did you test the latest `bugfix-2.1.x` code?
Yes, and the problem still exists.
### Bug Description
I discovered a problem after I finished a 24h print: The part which I wanted to print should …
-
### Wiki Search Terms
UART; Homing
### Controller Board
Single esp32 with 2 tmc2209
### Machine Description
Simple machine with two axis controlled by a TMC2209
### Input Circuits
…
-
As raised in #300, there's a suggestion to add more varieties of motor, such as the L298N.
> I believe to 'properly' support the L298N we'd need a Motor class with (Digital_forwards, Digital_backward…
-
[I](url
[Configuration.txt](https://github.com/bigtreetech/BIGTREETECH-SKR-V1.3/files/5579359/Configuration.txt)
[Configuration_adv.txt](https://github.com/bigtreetech/BIGTREETECH-SKR-V1.3/files/5…
-
Good morning,
I cannot figure out how to wire dual Z to the S42B drivers on my SKR 1.4 turbo. It appears that i could use the adapter as well as the CLS pins on the board, but am not sure if this w…