-
RFLink Gateway is an Ardunio Mega with serial uart interface supporting a huge amount of cheap 433Mhz devices and sensors. Please see the project page for more information and the very simple protocol…
-
We have noticed that when we give certain commands in init, for servo positions and for the digital outputs on the device interface module specifically, they do not always take effect. They will take …
-
4 fans should be placed on the base, on plastic caps behind primary mirror.
- [x] mount
- [x] connect power (12 V for the fans, Arduino should be powered via USB)
- [x] install relays and arduino cont…
frnhr updated
8 years ago
-
Hello everyone, my name is Slawek, this is my first post in this topic.
Encouraged by Andreas, i would like to present some work with raspberry pi LCD connected to UI board.
This LCD module has res…
-
Hi,
I have a z-stick gen5 from Aeotec, and I have serious problems for a a week now:
- either I loose a few devices (with red banner) = no more refresh of values, dead device, ...
- or Domoticz com…
-
I'd love to have one of these on my desk at work, but I can't seem to find the device on any site, and even looking for the Bluetooth Service UUID doesn't turn up much in Google.
Did you build this…
-
I can't find any trace of the ZWave implementation of a Rollershutter component. Nobody got around implementing it or is there a not obvious problem?
l00mi updated
7 years ago
-
I'm using a sonoff basic. When I get to step #4, when I'm supposed to connect to FinalStage SSID, FinalStage never comes. The firmware never seems to flash since I am able to continue to use the swit…
-
I installed octomap using sudo apt-get install ros-kinetic-octomap
then tried to install octovis using:
sudo apt-get install ros-kinetic-octovis
it shows E: unable to locate package
What could b…
-
As a first time PI user.. I am very confused as to what is needed to make this work.
I have the PI setup and installed
I cloned the repository and configured the conf files and moved them to the etc…