-
Hello,
i would be happy if i could prepare operations for CNC milling directly in OpenSCAD code.
Currently i have to export stl and import it into some software like [PyCAM](http://pycam.sourcefor…
-
Hi Martin,
First of all, thank you for this wonderful software.
I was able install Grbl 1.1J and use OpenCNCPilot to move all 3 axis using manual mode as well as using Keyboard. Just wanted to mak…
-
Is it possible to separate PWM out signal to two pins like on co2 laser control boards?
It would be easier for connecting with psu.The commercial borads have pwm out that holds the value constant whi…
-
I am trying to configure the CTRL+X (0x18: Soft-Reset) command on my screen using the firmware for laser
Tell me how to set up an additional button for sending a command CTRL + X ?
My screen MKS TFT…
-
Hey -I got excited about seeing this AppImage hoping this would give me access to run DDCut on my Linux box. I've tried versions:
**DDCut-V-5.1.7.AppImage, DDCut-V-5.1.6.AppImage, and DDCut-V-5.1.5.…
-
Hello
I'm just starting fun with laser cutting and building my own CO2 laser. Basically, it is done just having some problems with GRBL.
Every single time when I plug in the power supply for drivers…
-
At the organisers' meeting, the subject of marketing, website and general vision of DoES was raised multiple times, so that's something that's now actively being looked in to.
> If you have any inp…
-
**Describe the bug**
Loading a very large GCode file chokes Platform running on RasPi.
**To reproduce**
Steps to reproduce the behavior:
1. Start UGS Platform (I used build DL'd on 11/18/2020), …
-
Hello,
Nice work! I haven't tried it yet but i'm planning on doing it this weekend.
I too have a hotwire cutter and had the letartare 8c2 code changed to work on a RAMPS 1.4 board.
But you go…
-
#### Description
Looking at the code, it appears that GrblController is hard-coded to Character Counting Streaming Protocol. I have compiled Grbl to enable Echo commands on my Arduino, but this ha…