-
I want to speed up the development of RZ / A2M through Linux, but need to use PWM signal to control motor. I want to confirm whether RZ / A2M can realize PWM signal output through programming under Li…
-
### Variant
PWM
### Control type
FOC
### Control mode
Voltage
### What is the bug and how to reproduce it ?
Hello, and thanks for all the wonderful work you did on this firmware.
I'm currentl…
-
### Problem description
using homeassistant/home-assistant:2024.3 on a Raspberry pi 3, having no issue with other zigbee devices.
After syncing TS0601 by_TZE204_r0jdjrvi smart curtain motor with …
-
From reading around it seems:
* Primarily it's bi-level machines that are interesting as quick ad-hoc ventilator replacements because they can generate much larger pressure differentials, making it…
-
The idea here is to develop a single command that we can run in the pits which will sequentially go through and test that all our motors and actuators are working correctly. If any aren't we can gener…
-
When a motor is disconnected while ground control is running the firmware does not stop the run.
If a break in the closed loop fails the cut should be halted and not continue to run.
-
Servo model: RX-28
Setup: DynamixelShield on ArduinoUNO. Debug serial using another ArduinoUNO as UART-Serial bridge.
Situation: I recently purchased the DynamixelShield for a project to control a c…
-
## Describe the bug
I am trying to control the motor [iHSV60](https://www.jmc-motor.com/product/102.html) but I'm getting the following error when calling the **/init** service. The configuration I'm…
-
Speed is not controllable on Bank A Motor 1 when using Arduino IDEs that have an I2C frequency other than 50000. Mindsensors support is currently working on a fix for this issue.
-
Hi, and thanks for working on improving BLHeli-S.
I'm sure you're aware of this, it's a 'feature' of BLHeli-S, but I was wondering if you can do anything to improve it a bit.
What I'm referring …