-
My code compiles fine but when I get to the downloading part of a new install I get the following error. At the bottom of the error list it says the board is not connected but when I get the board in…
ghost updated
3 years ago
-
### Description
Compilation error when defining serial port as -1
### Steps to Reproduce
In config.h
```
#define SERIAL_PORT -1
#define MOTHERBOARD BOARD_RUMBA
```
Compiling produces t…
-
Not sure if I'm missing something but the auto-level XY offsets are only for one nozzle setups. As I have a dual extruder shall I just set it up with my most used nozzle?
-
Is it enough to connect TX pin 2 on EMU Exp port and GND or also connect RX for handshake ? Cant see any handshake in the code though. Have made a new struct file on my fw 1.207 in EMU. Have also test…
-
A support of the MegaCoreX will helpful because there are other boards with MegaAvr0 chips,
(Curiosity Nano, ATmega4809 Xplained Pro ...) which are not supported by Arduino directly.
https://github.…
-
Can this be integrated into marlin to be detected by windows 10?
https://docs.microsoft.com/en-us/windows-hardware/drivers/3dprint/microsoft-standard-driver-for-3d-printers-
-
Hello!
is this charger supported? it has an atmega chip, and the layout looks very similar to the original B6, but is not identical. The original software is full of bugs..
https://monstertroni…
-
A while ago we had a big discussion on what ICE made sense for the AVR's. Some people got MK-II's and others got the Dragon.
Are those the 'right' tools for doing serious debug on the 32-bit plat…
-
Can someone help me figure out why DRV_STATUS is always returning FFFFFF? The code says to check loose connections, but nothing is loose. Its failing on the "Testing Connection" section. I looked at t…
-
good morning, my name is Roberto. I bought the vigotec laser model VGL x7 with Wi-Fi (which I would not use at all). My question is: I would like to put the firmware of laser GRBL 1.1f but if it does…