-
Game starts loading mods, then closes suddenly. Logs say something about mixin apply failure.
- NeoForge 47.1.106 for Minecraft 1.20.1
- Create version 0.5.1j
- Petrolpark's Library 1.0.6
- …
-
I have a X20 Pro AW and TD SR10. I updated the TD SR10 firmware and calibrated it before installing it.
I had to move right ailerons to another channel in the receiver options so I could get SPort …
-
A common scenario (at least for gliders), is to have a 4 servo wing, 2 for aileron and 2 for flaps.
It is also common to have 'dual rates' on the ailerons which can be done via the Weights / Rates p…
-
Problem: Flaps or ailerons up or down in the same direction
Flight phase: thermal, speed, landing
How can I reverse a control surface to adjust the control surface deflections in the same directio…
-
I suggest that the new model wizard be changed. If you select no tail it should ask whether to configure for elevons, or delta with seperate ailerons and elevators.
-
The page fail to load the font from a URL.
check line12:
-
When printing the split model model for the wing you end up with the aileron surface split in half, with nothing but glue holding the pieces together.
For printers with not enough Z height it would b…
-
I am putting servo settings to snap roll on a the momentary switch. I did this by creating a flight mode activated by this switch. I created a mix for rudder elevator and ailerons with a 2 point curv…
-
**[For gliders]**
- [ ] if 2 ailerons and 2 flaps, then propose a butterfly mix (which parameters?)
- [ ] propose thermals (which parameters?)
- [ ] if it is a 2 ailerons glider, propose to add a f…
-
To me it seems the ailerons have very little authority, though that's subjective, do you know whether it's a bug or a feature?
ghost updated
7 years ago