-
Sir,
I have an ALTERA FPGA Cyclone II EP2C5T144 board. Is it possible to use this with LinuxCNC-RIO for real-time I/O? If yes, could you provide any guidance or steps to make it work?
Thanks!
-
Is there any schematic to add a ch376 interface to telestrat? I am playing with the telestrat cartridges in a fpga telestrat and everything works as expected, but no I/O.
-
For the last commit [91c135a]
`PREFIX=test1 TARGET=fpga NUM_CORES=4 make` gives
```
text macro "PLATFORM_MEMORY_ADDR_WIDTH" is undefined File: local_mem_cfg_pkg.sv Line: 49
text macro "PLATFO…
-
Hello, I saw the issue you posted before, as shown below. I have the same problem as you did. My MC only supports DFI, but I want to verify it on xilinx MIG. I have learned some transfer processes bef…
-
If, in your JTAG chain, you have more than one TAP with the same IDCODE, you can only access SLD nodes on the first chain.
For example, you have two identical Altera FPGA chip, say S10s, on the jta…
-
Hey, im trying to add support for the classic Cyclone II (its a very very common entry board to FPGA field)
This is the board that im trying to support: https://www.ebay.com/itm/355257902298?mkcid=16…
-
Hello,
i've searched the Aliexpress for absolute cheapest FPGA boards and i've found very cheap devices that i think might be worth supporting:
- Noname chinese bargain FPGAs
- https://hackaday…
-
Hey, i have never use a FPGA borad, i will try the prodject on a smalelr device to understund more and mabye in the futurce buy and bigger board.
I looked up Altera MAX II EPM240. and under stund th…
-
I have been looking for a solution to reuse the old mobile phones screens on hackerspaces and makerspaces, and the cheapest board out there is a cyclon II
Do you think it is doable to port your cod…
-
How can I synthesize this using Quartus Prime ( windows). I have tried Adding the project and Running the files , but all i get are analysis error
Note : files are added as it is in project.
for E…