-
Hello.
I am using the CANopenNode stack on my B-G431B-ESC1. The basic communication works already.
Now I want to send information about errors to other devices. When setting a bit of OD_RAM.x100…
-
PIO Core Call Error: "InvalidBoardManifest: Invalid board JSON manifest 'C:\\Users\\88691\\.platformio\\platforms\\ststm32\\boards\\disco_b_g431b_esc1.json'"
-
Discussion in forum here: https://community.simplefoc.com/t/b-g431b-esc1-hoverboard-motor-not-working-with-closed-loop-modes/898/18?u=runger
Do we want to add a feed-forward controller? discuss and…
-
https://github.com/owennewo/SimpleCAN/blob/1abb7f97978592e77db0f42ea0816a0b589cc002/examples/normal_standard_id/main.cpp#L44-L47
which leads to:
https://github.com/owennewo/SimpleCAN/blob/1abb7f…
-
Hi, awesome library port.
I came across this library testing out motors and looking more into the MIT actuators by Ben.
I was using simpleFOC with this board and they found that full SPI is ava…
-
Hello Team,
Can we add support for the STM32G4 line of MCU's?
No generic board profiles seem to exist for these at this time.
Regards
-
DoD: PCB board that is able to handle:
- Single Stepper motor (4 wire)
- Single CAN communication
- Power in noisy automotive env (requirements pending, likely 12V @ 10A peak)
- STM32
Saved…
amzoo updated
3 years ago
-
Decide which protocol to use
Solder wire
Make communication between working
-
PIO Core Call Error: "The current working directory C:\\Users\\Hendrik Horn\\Documents\\PlatformIO\\Projects\\rx will be used for the project.\r\n\r\nThe next files/directories have been created in C:…
-
Hey there, I was trying out the sample and as far as I can tell, it seems to be working, but after a few iterations I end up getting an error of `CAN Error: Tx buffer overrun`.
You will have to forg…