-
Hi,
I've been trying to set up my machine with the Trinamic TMC 5160 drivers that use SPI mode. Looking through this current implementation, it doesn't look like the SPI bus was implemented as a HA…
-
Hi @terjeio , would it be possible to add plugin for Nextion displays ? [https://nextion.tech](https://nextion.tech)
I mean something like when you press a button it sends a Gcode command to serial.p…
-
Hi @terjeio
Using ESP32 device with WebUI 3.0.0.a37.GH2
grblHAL firmware 1.1f-20230501
Device is ESP32 Wroom dev board
Using 4 axis WebUI is unable to parse data.
![ParsingError2](https://use…
-
M10CUBE format CNC Brakeout Nucleo64
-
I'm not sure if there's a better way to inquire about the current status of this project, but where does it stand as of August 2022? Are the published PCBs working, and are there ways to program the M…
-
Freely discuss your opinions on an ARM platform for Grbl, moving forward after v1.1.
-
Hey guys,
Just wanted to get this on the list for grbl mega. Not sure how this would be done but it would be nice to have the capability to do threading with a grbl controlled lathe.
If this shoul…
tklus updated
3 years ago
-
I followed the instructions given in "compiling girbalHAL section" to compile the driver for 6-axis. but after downlading biard, the driver is still 3 axis.
I edited the cnc3040 file for needs, and …
-
I want to run this project, but I have a lot of problems。
I use TM4C123GXL board as MPG controller,I use EXP432P401R board as grblhal controller,The source code of the grblhal controller is https:/…
-
Hi.
I want to use the keyboard, but I have encountered some problems. I use MSP430G2554 to drive the keyboard. The IIC interface of MSP430G2554 (keyboard board) is connected to tiva-c (DRO board), …