-
-
The internal electronics of the fuselage need to be accessible in the field, but also stable in flight.
Any mounting apparatus or technique should be lightweight.
Currently the discussion revolves ar…
-
Design and 3D print or mill/route part that slides into PVC housing and serves as chassis for
- Boron and stacked Adalogger Featherwing
- Battery pack
- Cell antenna
-
###Parts
- [ ] moisture sensor (capacitive?)
- [ ] temperature sensor?
- [ ] light sensor
- [ ] pump
- [ ]
-
Hi there!
Thanks for putting together this whole device and for writing up the publication in eNeuro! I work at the University of Sussex in the UK and we are starting to replicate the design for Ca…
-
The old design, [here](https://www.littlefrenchkev.com/bluetooth-nerf-turret), uses a 9v supply and an arduino. However, we'll use a 5v supply with a pi zero. This means we don't need the voltage conv…
-
## *Lab/Experiment(s) Hosting Request*
Use this issue to get your lab and experiment repositories hosted on Virtual Labs. This issue also is used to host labs and their experiments that have been mig…
-
-
Use this to request the hosting of a Phase 2 lab.
Lab name: Hybrid Electronics Lab
Broad Area: Electronics & Communications Engineering
Lab Repo URL:
Design and Implementation of Various Ari…
-
As discussed, basic concepts are to be added from the following sections
- **Analog**: Buck, Boost Converters, Filters, Basics of RLC, Timer circuits, diodes, MOSFETS, BJT, H-Bridge Circuits
- **PCB…