-
### Printer model
Mk4
### Firmware version
6.0.3
### Upgrades and modifications
Prusa Original Enclosure
### Printing from...
Prusa Connect
### Describe the bug
During a pri…
-
### Bambu Studio Version
1.9.3.50
### Where is the application from?
Bambu Lab Official website
### OS version
Windows 10 & macOS Sonoma 14.5
### Additional system information
_No response_
##…
-
Hi the filament break (beside load) button always reverts to "off" after you power down. Is there a way to save it on?
Thanks
-
I calibrated at room temperature my filament sensor using drill bits 1.5, 1.6, 1.7, 1.8, 1.9, 2.0 mm (verified with a micrometer) and I found that the sensor behaviour is not linear, and the values pr…
-
This is just to track and not forget for the next version to add this: https://github.com/bigtreetech/smart-filament-detection-module
```
[filament_switch_sensor switch_sensor]
switch_pin: gpio…
-
Feature Request
===============
**Problem**
Currently for whatever reason no message gets sent via text on filament out. Also the procedure currently does not lift the extruder high enough and so…
-
Pause spaghetti detection on filament runout.
-
Firmware: 1.0.5beta
Currently the filament runout sensor only works for prints from SD card. Octoprint cannot detect runouts.
I don't know much about GCODE but it seems that the M115 command gets …
-
I don't know why, but sometimes the unload fails and I'm sure the synced unload not works if it fails.
It tries to unload to the buffer but the filament is still inside the extruder (toolhead sensor …
-
I'm running the BTT smart Sensor v2 on a Voron 2.4 with klipper. When I print things seem to work correctly until some point where the switch sensor gets triggered. When I heat the hotend and extrude,…