-
DONE: When Acquired motors
-
- we rely on cheap continuous rotation analog sg90 servo motors for the flippers/ears on the RSC
- they cause vibrations, noise and electrical feedback noise when operating
- no position feedback mea…
-
Hello Naoki as i told before your code is the most advanced among others.
My thing ... i tried to modify the cybergear_socketcan_driver_node.cpp to accept more motors but nothing seems to work ... s…
-
Flashed an original tinyhawk (MatekF411RX FRSKY). Everything seemed to work, but two of the four motors (which did work prior to flashing) no longer spin up. The front left (PIN0 - PB7) and back left …
-
### Guidelines
- [X] I checked for duplicate bug reports
- [X] I tried to find a way to reproduce the bug
### Version
Development (Unstable)
### What happened? What did you expect to happ…
-
When connected to a Control+ hub, my large spike prime motor works properly, but when connected to a Boost hub, even manually sliding the power slider does nothing on both c and d ports. I am using th…
-
When I plugged in the 330s into the driver board (without a voltage reducer), which was plugged into the 12V power adapter, it immediately went up in smoke... am I supposed to use the voltage reducer …
-
I recently created the [3MS](https://github.com/3DCoded/3MS), a modular multimaterial system for Klipper. Currently it has custom macros developed by me, but I want to control it via HappyHare for mor…
-
### Variant
HOVERCAR
### Control type
FOC
### Control mode
Torque
### Description
How disable backward spinning motors? (Brake + fast accelerate)
-
Good afternoon, I have this problem that I can't figure out: the z motors don't follow the created mesh, they are practically stationary...
Can you help me solve this? Thank you
[klippy.log](https:/…