-
In the page 8 of ICS307 datasheet, it mentioned the maximum clock input frequency is 50MHz, however, currently it looks like it is connected directly to the 100MHz clock source:
https://github.com/to…
-
I use Z-System (NZCOM) with z80pack on my Linux machine and have come to rely on the z80pack RTC for timestamping support. Unfortunately, the pano_z80 BIOS doesn't seem to have implemented it and I g…
-
The LiteX BIOS reports lots and lots of memory test failures on the Rev C, but none on the Rev B (a log is attached). One clue is that the errors are always in the lower 16 bits of the word.
AFAIK…
-
I have a bunch of these G1 devices I picked up cheap a few years ago to toy around with. Did you happen to have any of them or just the G2? They have a smaller device in them that is supported by webp…
-
Hi!
We are working on getting the panologic-g2 into the [`timvideos/litex-buildenv`](https://github.com/timvideos/litex-buildenv/pull/223) repository and [`litex-hub/linux-on-litex-vexriscv`](https…
-
https://en.wikipedia.org/wiki/Data_compression
## [shapes and symmetries of groups](http://www.coloring-book.co/?pageName=road-map)
http://www.coloring-book.co/
https://news.ycombinator.com/ite…
-
More of a question than an issue, so please bear with me.
I got into FPGAs from the MiSTer project, and was intrigued to see how large the (G2) Pano Logic’s FPGA is, even though it doesn’t have a c…
-
Hi
I have flashed the loader onto it using JTAG, but when I power cycle it, it does not appear on the network.
It seems the network is not activated as the lights on the network adapter do not light…
-
Support for Rev A
-
We've been working on adding Litex support for Pano Logic G2 board (https://github.com/tomverbeure/panologic-g2) we've added basic support in Litex-buildenv (https://github.com/timvideos/litex-builden…