-
User describes an issue getting reliable 30fps in a setup with two miniscopes and a pointgrey camera being triggered by pycontrol.
Setup: two miniscopes each connected to a BNC port of the pycontr…
-
Now I have two pointgrey cameras and want to run them at the same time. When I run two launch file for each camera, it seems fine. But when I run two rviz to subscribe the two topics for each camera, …
-
Hi all,
I am using PointGrey Blackfly Gige camera, and i run rosrun pointgrey_camera_driver list_cameras, i was given that there is no camera detected on computer. I couldn`t run camera driver as …
-
According to line 896 the **Flea3 GigE Camera FL3-GE-14S3C-C** is an accepted GigE-Camera, but does not support "packet resend".
As there is no full support for Flea3 cameras, there might sti…
-
For interacting with PointGrey cameras, et al.
Expose settings as params in the Property panel, ATM only **ColorProcessing** and **Index** of camera are configurable, consider exposing, if not the …
-
Calling GetCameraInfo takes 40ms, but the result never changes. Many pointgrey cameras can get higher than 24fps, so it'd probably be good to move that somewhere so it only runs once.
-
I have a Point Grey Flea3 camera using pointgrey_camera_driver. Every time I launch it in ROS the frame rate is 7 FPS. I am able to change the frame rate to 30 FPS using rqt_reconfigure. I would like…
-
I set up my two Blackfly cameras according to the following instructions using the correct GPIO cables: https://www.ptgrey.com/tan/11052. What steps do I need to follow to enable time syncing using t…
-
Hi Im using Ubuntu 16.04 and ROS kinetic. Would like to do stereo calibration with two Chamelon3 PointGrey Cameras. I found that ROS drivers for Chameleon3 pointgrey_camera_driver support only FlyCapt…
-
Hi!!
I run the launch file(pointgrey_camera_driver stereo.launch) but only one image is played.
rosrun pointgrey_camera_driver list_cameras
Number of cameras found: 2
[0]Serial: 18154835, Model…