-
## Version of the moonraker integration
1.3.4
## Describe your setup
Klipper, Moonraker, Mainsail, Raspi.
Relay connected to the GPIO on the pi to control power to the printer board (SKR m…
-
Hello, is it possible to address the power and the USB interface externally via an API/ webhook? This would make it possible to integrate this switch into a smart home such as HomeKit or Home Assistan…
-
I was about to use a power switch setup using the LUA script with telemetry. The power switch is connected to pin 18 as FBUS on my TD R18 RX running v1.0.12 firmware. Initially the LUA script sees the…
-
There's one room where I want to achieve the following (given dumb wall switches):
- When I power on the light via a dumb wall switch: it should start at the lowest possible brightness level
- But…
cswrd updated
2 weeks ago
-
[BOM ](Tympan_Rev_F/Production/Tympan_Rev_F_BOM.xlsx
)shows CL-SB-22A-11T, which is the Rev-E side switch, but should be CL-SB-22A-01T, the Rev-F top switch.
![image](https://github.com/user-attac…
-
We should drop the ryzenadj power profile in favor of the PPD supported `platform_profile`
```
[gamer@opineo acpi]$ pwd
/sys/firmware/acpi
[gamer@opineo acpi]$ cat platform_profile_choices
low…
-
Hi,
Could you extend the list of options for the right-click on the menu bar?
I want to cycle between Low and High power modes, but currently, it cycles between Low and Automatic (even if HPM was …
-
### What happened?
Same as https://github.com/Koenkk/zigbee2mqtt/issues/20716
![grafik](https://github.com/user-attachments/assets/e65fe11f-80ba-472c-b792-a86cec798456)
![grafik](https://github.com…
-
### Describe the Bug
The keyboard is not operating in the expected way with some positions of power switch. The following happens:
1. Bluetooth selected - the keyboard operates in bluetooth mode as …
-
Hi, is there any better way how can I control my thermostat? I am using 230 V valves (https://www.elektrobock.cz/termoelektricky-pohon/p1734) controlled by the Sonoff board.
It takes a few minutes …