-
Hi there,
I am trying to set up a transmitter receiver with your library.
what would be the appropriate way to send potentiometer values over 2 cc2500 and pro micro?
sorry, but I am not familiar wi…
giubu updated
3 years ago
-
Hi, just wondering if this could help me to extract sensor data while streaming ¿It is possible to use the metadata to feed a control system?
Like an FPV drone while in flight (intensive use) or RC …
-
Hi mate, Iv seem your BLE module on oshpark and Iv seem that the new one has been developed to work with servo motors and esc's, I was wondering if you have had a chance to make a small bluetooth hand…
-
Hello. I recently read your paper and I am interested in implementing your dead reckoning algorithm on an RC car equipped with a raspberry pi, GPS, and IMU. I was wondering if you had any suggestions …
-
## read later
http://www.makerfaire.com.tw/
https://www.facebook.com/makerfairetaipei/
## boards
* http://longboard.com.tw/
* http://onboard.com.tw/
## bots supporting scratch
compare
[…
-
**Is your feature request related to a problem? Please describe.**
There are a number of times I want to print the shell of a model. At times I've been able to do this with spiralize outer contour/v…
-
Hi conuthead
thank you for your project .
Now I use blheli32 ESC for RC car, the effect is not very good. So I want to try your firmware.
Can MultiRotor ESC download your firmware for RC car?
Than…
-
### Describe the bug
Remote control (both normal for RC cars and for normal vehicles) immediately shows disconnect message after trying to control the vehicle.
### Attach save file
[Квойн-trimmed.t…
-
I'm using rc-switch with fs1000a (433Mhz) module and it works fine, but i'm trying to read my car key (with the rolling code i can't use that input for nothing, just for learning) but it doesn't read …
-
I haven't been able to fully test every feature yet. As someone using your code for the first time, I wanted to share some experiences I had, which might be helpful for further development.
First o…