-
The ability to download pre-built firmware that works on your Makerbot is one of the best features of ReplicatorG. To do this for RepRap is a bit more difficult since there is much more variation in e…
-
Trying to configure S42B v1.1 with Duet Reprap Firmware v3 Timing/Pulse
This is what I am using now
M569 P8 R0 S0 T3.33:3.33:3:0
What settings should I be using for the S42B v 1.1 ?
Refere…
-
Hi Michael,
Thank you for the site - it works wonderful if you have Marlin. I have recently changed to a Duet2 setup, and now the acceleration/jerking pages are an issue as the commands are differe…
-
[https://reprap.org/wiki/RepRap_Firmware](https://reprap.org/wiki/RepRap_Firmware)
and perhaps talking to DC42 in the forums @ [https://forum.duet3d.com/](https://forum.duet3d.com/)
Duet3d has an ex…
-
I was wondering if any plans to enable this to monitor prints directly from a printer running RepRap Firmware (I.e. on a Duet) without having to have a Pi running Octoprint acting as a middle man?
…
-
### The problem
It's quite an evasive bug. If I do print this file it prints the 1st layer flawlessly. After that it frequently (like at least 2 times per layer) it hits the 100% processor mark (chec…
-
### Description of the bug
While installing version 2.7.4 on the Mac with an M1 Ultra chip, I was asked to select which printer I was going to use, I selected the Prusa XL 2T I have. A couple of st…
-
**Printer type** - MK4
**Printer firmware version** - 5.1.2 release and newer
**Original or Custom firmware** - Custom (#define HEATER_0_MAXTEMP 320)
**Optional upgrades** - Micro Swiss CM2 R…
-
I have a CR10S-Pro which normally use a touchscreen. But i didn't like and replaced it with a 12864 reprap full graphic controller. That controller/display works since weeks. So i thought, that this m…
-
See http://forums.reprap.org/read.php?245,516838,517132#msg-517132 , a first success of the announcements. German, but messages are copy&pasted.
With Configtool:
> F:\Program Files (x86)\Arduino -c …