-
I've installed, which went very smooth. My rig uses CAT PTT not VOX. It appears that the script does not send the rigctl T 1 or T 0 commands to the rig. This is my rigctl statement in Patmenu Confi…
-
Morning,
I'm coming up with this issue - the rigctl-interface keeps getting the frequency etc muddled...
Any ideas?
73 Michael
. This was seen on U…
-
I see that you have a rigctl server which is great, and I might be able to utilize this to do what I'd like. However a rigctl client module would be even better.
What I'd like to be able to do is h…
-
Sorry for bringing this up as an issue, but I do not seem to be able to connect to an IC-705 over WiFi using rigcontrol. Using the following command line:
`
rigctl -m 3085 -c 0xA4 -r 192.168.1.254:5…
-
Hi,
I've been debugging an issue with Hamlib where it intermittently toggles the VFO, which wears out relays in the transceiver and causes quite a lot of pain with receiving SSTV transmissions unle…
-
**Hardware**
- CPU: Intel(R) Core(TM) i5-3470
- RAM: 8G DIMM DDR3 Synchronous 1600 MHz
- GPU: built-in
- SDR: Local SDRPlay clone
**Software**
- Operating System: Ubuntu 22.04.4 LTS
- SDR++: …
sq2mo updated
2 months ago
-
Issue withdrawn.
Thought that as rigctl transceiver model # 2 had to be used. But looking in the source code found that what is emulated is a Kenwood TS-2000, hence rigctl model number 2014. The use …
-
I'm using a OSX 11.6, hamlib 4.4, and gpredict 2.2.1. I installed gpredict via macports then again via homebrew. I also tried hamlib 4.0. All the varieties have the same problem.
When controllin…
-
I'd like to be able to use fldigi or wsjt-x with my SDR. These programs support hamlib, and I can get them to control the SoftRock directly (set frequency, tx/rx, etc) and run a trivial gnuradio progr…