-
The TMC-API is getting a rework of its core structure. This is to make the direct accessing of chip registers as easy as possible.
For detailed descriptions of how to use the updated TMC-API, see h…
-
I want to connect 2 TMC2209 to arduino ,
when i send 1 in serial just one stepper worked wich have address 0b00 the otherone with ADD 0b11 not worked , however MS1 MS2 with Vio for Add 0b11
this…
-
Hi I cannot seen to get the simple example to compile I get the following error
use of deleted function 'TMC2208Stepper::TMC2208Stepper(uint16_t, uint16_t, float)'
0; i--) {
digitalWrite(…
-
Hi all,
I am trying to set up a small machine using the TMC 2209 driver and want to use the sensorless homing feature. So my idea is to have the stepper run until it reaches the end and have it stop …
-
Hi everyone, I bought two tmc5160 from bigtreetech more specifically these https://www.biqu.equipment/products/bigtreetech-tmc5160-v1-0-driver-spi-mode-silent-high-precision-stepstick-stepper-motor-dr…
ghost updated
3 years ago
-
I am trying to drive a nema23/56 stepper with a TMC2660 on the TMC2660-BOB breakout board, with an arduino mega 2560. I'm attempting to run hardware SPI on the mega SPI pins (50 (MISO), 51 (MOSI), 52 …
-
Hey all,
I'm using the example "Simple" sketch and as soon as I use `driver.begin();` it always results in exceptions thrown.
Sorry if I'm missing something obvious, but can't figure out what's …
-
Hi, i wrote a sketch using your library on an Arduino Nano while waiting for an ESP32 to arrive, but when i tried to upload that sketch to the ESP32, VSCode threw an error that your library only suppo…
-
Hi teemuatlut, you did a great job with this library!
I am having a little problem that I can't solve with your documentation (certainly because I am not much of a programmer)
I want to swap old A49…
-
Hello,
I'm currently trying to drive a stepper motor which drives a linear stage to move something around. I have a fysetc v3.0 TMC2209 connected to a CNC shield v3 which sits on an arduino mega 25…