-
Dear Smartavan Team,
This is rather not an issue but a question, and I hope that you don't mind that I put it here.
According to [Fabian's documentation](https://github.com/Fabian-Schmidt/esphom…
-
First of all - thanks for this wonderful ESP implementation to get the Truma "under control".
My setup is a Combi 4E (C4.01.02 / 50.00, H1.01.00 / 340.0A) together with a dedicated esp32. Further sen…
-
Hi, I just bought Aventa and would like to integrate it.
Can I help you with remote debugging and sponsor your work? (Feel free to contact me privately.)
-
Hi there,
very advanced hard- and software indeed! Very impressed!
I have a Truma Contol 4 Heater and Truma A/C operating with the Truma iNet Box and intend to switch the iNet Box for a custom so…
-
Hi Fabian,
thank you for your great ESPHome-Truma Inetbox connectivity.
I use this connectivity on my vacation last week.
It was very cold and I had managed my Truma heating with Home Assistant…
-
Hallo,
ich habe deine Software nochmal auf einer neuen Raspi Installation aufgesetzt.
Das Skript starte ich von Hand, den service habe ich erst gar nicht enabled.
Wenn ich nun truma_service al…
-
Hi Fabian,
first of all, thanks for this project.
I tried to use it in my RV with Truma Combi 4, but it don´t work.
My Truma Hardware is:
C4.01.01 / 0050.00
H1.02.00 / 0300.02
I tried with …
elojn updated
7 months ago
-
Hi @Fabian-Schmidt
Could you help me making this work with my Truma Combi 6L, iNet ready CP plus C3.00.01 H5.00.00 ?
I'm not sure if it's supposed to be supported by your project. I'm trying it…
-
Hello Fabian.
I am excited about your development of the INet Box with ESPHome in the Home Assistant.
Thank you for that.
I have a motorhome with a Truma Combi 6E.
The connection is going very w…
uhuck updated
9 months ago
-
I have connected to a Truma 6C and used the demo yaml but I get these messages all the time:
hb1/debug [W][truma_inetbox.LinBusListener:363]: PID 3C 7F.06.B2 partial data received
hb1/debug […