-
Hello,
Is it possible to add support for TTGO T-Internet?
https://www.tindie.com/products/lora-aprs/lora-on-poe-esp32-board/
Here is a version that supports it:
https://github.com/lora-aprs/Lo…
-
Hi, I'm trying to attach a BME280 sensor to my Lilygo TTGO LoRa T3-S3 that I just bought, but the pinout on the site is not correct.
![H594-PIN-DIAGRAM_600x600](https://github.com/LilyGO/TTGO-LORA32/…
-
Hi, I'm trying to attach a BME280 sensor to my Lilygo TTGO LoRa T3-S3 that I just bought, but the pinout on the site is not correct.
![H594-PIN-DIAGRAM_600x600](https://github.com/LilyGO/TTGO-LORA32/…
-
### Category
Hardware Compatibility
### Hardware
RAK 4631, TTGOs
### Firmware Version
2.3.6
### Description
I have two PMSA 0031 sensors that are supposed to be Meshtastic compati…
-
I bought a few TTGO T-Display v1.1 modules awhile back and put them in a drawer. When I exhausted my supply of the older boards, I discovered that I couldn't communicate with the newer boards. Debia…
-
When I run " python jade_ota.py --noagent "
The TTGO asks for a pin, then shows the old and new firmware to confirm
then very shortly shows the progress bar and then shuts off..
any idea what th…
-
I would like to power a Lilygo ttgo t-call controller (esp32 + sim800) with LiPo battery (type 18650).
Under the board there is a jst-ph 2mm connector but, if I connect, the LiPo battery to this conn…
-
Hello,
I'm running example code like deepsleep or wifi. It works but the Serial is all scramble (not UTF-8 ?)
At first I didn't get any readable caracter, I swtich to `Serial.begin(9600);` it's be…
-
Good morning
Your program "Temperature example" is presented as possible on ESP32+ module sx12xx.
But the "platformIO" of this github is specified as suitable for a "ttgo-lora-v1".
Is it the same t…
-
When trying to compile the PC Emulator code, I come across this bunch of errors:
In file included from C:\Users\tapeg\AppData\Local\Temp\.arduinoIDE-unsaved2024216-7412-lawcjw.zwokr\PCEmulator\mach…