-
adding in the voltage constraints from the paper is causing a lot of infeasible issues. without it, just have the hvdc limit issue. with it, have listed below:
model.name="unknown";
- terminatio…
-
I've got a Tripp-Lite SmartLCD to provide power to my rack and desk, got the CGI scripts served up on a raspberry pi and noticed in upsstats.cgi that output voltage was 1162.0v instead of 116.2v.
I…
-
I've built one of these and I am getting -12 and 5v on the header, but 4.9v on the +12. I checked the power coming from pin 1 on the IC, and its 1.3v (?) but 4.6v on the VBUS pin on the other side of …
-
## current functionality
Voltage output shown on multimeter is 219.5V.
Voltage output shown on voltage regulator is ~150V.
## desired functionality
Voltage output shown on voltage regulator display…
-
Based on https://www.youtube.com/watch?v=C1-xoKf7d_Y&lc=UgyrKieu0w_wG4IoNEp4AaABAg
> [@TiborPolacsek](https://www.youtube.com/@TiborPolacsek)
(https://www.youtube.com/watch?v=C1-xoKf7d_Y&lc=UgyrKi…
-
I've noted some logical issues with the new functionality of sending voltage as telemetry (version 2024.9.23)
- the initial state of this function is enabled, even though the web config switch is o…
-
@lewisxhe on my board it is resulting in 0.013V .... can you check? all supply pins of the modem's really connected?
-
I don't know if everyone needs this feature, but if the voltage of the car is very low, I want to be able to receive a "beep beep" alert from the transmitter.
-
Greetings. I have an esp32 board that works with jk-bms via modbus with the following firmware:
github://syssi/esphome-jk-bms@main
and also your great project i have successfully connected my POW-…
-
In the application, I can not find this option for the BMS, is it named differently?
Thanks