meta-nezha

Description

This repository is a Yocto Project meta layer that provides early support for a RISC-V based board called Nezha. It is an educational project prepared as the main part of a master's project.

How to build

To build nezha-image-minimal you should run command below:

$ SHELL=bash kas-docker build meta-nezha/kas/nezha-minimal.yml

Software BoM

Meta layers

Key repositories

meta-nezha-bsp layer contains custom recipes for u-boot, Linux, OpenSBI and boot0. This recipes get code from fork of repos patched / created by smaeul:

OpenSBI: d1-wip branch
u-boot: d1-wip branch
Linux: riscv/d1-wip branch
boot0: mainline branch

Current status

19.11.2021

System boots now. Kernel Panic error was caused by rng which is used to generate entropy. It cannot handle SIGSEGV signal in libc-2.33. The solution for this was to replace the rng-tools with haveged.

14.11.2021

u-boot problem fixed with patch:

meta-nezha-bsp/recipes-bsp/u-boot/files/0001-sun20i-set-CONFIG_SYS_BOOTM_LEN.patch

kernel is booting to this moment:

[   10.792295] rngd[139]: unhandled signal 11 code 0x2 at 0x0000003fc72e1378 in libc-2.33.so[3fc727e000+fd000]
[   10.948096] CPU: 0 PID: 139 Comm: rngd Not tainted 5.14.0-rc4-nezha #1
[   11.051283] Hardware name: Allwinner D1 NeZha (DT)
[   11.101973] epc : 0000003fc72e1378 ra : 0000003fc72e1338 sp : 0000003fc72766a0
[   11.185902]  gp : 0000002ab2ca3800 tp : 0000003fc72778f0 t0 : 3434bfb4d190d97e
[  OK  ] Finished Update is Completed.
[   11.271992]  t1 : 0000002ab2c9b63c t2 : 7241a979ec7a6232 s0 : 0000003fc0000020
[   11.342274]  s1 : 0000003fc7381b00 a0 : 0000003fc0000000 a1 : 0000000000021000
[   11.380126] dwmac-sun8i 4500000.ethernet eth0: PHY [stmmac-0:01] driver [RTL8211F Gigabit Ethernet] (irq=POLL)
[   11.418634]  a2 : 0000000000000003 a3 : 0000000000004022 a4 : 0000003fc0000870
[   11.456520] dwmac-sun8i 4500000.ethernet eth0: Register MEM_TYPE_PAGE_POOL RxQ-0
[   11.504119]  a5 : 0000003fc0000028 a6 : 0000000000000000 a7 : fffffffffffff000
[   11.545471] dwmac-sun8i 4500000.ethernet eth0: No Safety Features support found
[   11.578202]  s2 : 0000003fc0000000 s3 : 00000000000008c8 s4 : 0000000000000000
[   11.652134] dwmac-sun8i 4500000.ethernet eth0: No MAC Management Counters available
[   11.680441]  s5 : 0000000000000006 s6 : 0000003ffff6f988 s7 : 0000003fc72778f0
[   11.732134] dwmac-sun8i 4500000.ethernet eth0: PTP not supported by HW
[   11.742784]  s8 : 0000003fc7277150 s9 : 0000000000000001 s10: 0000003fc73a1380
[   11.776764] dwmac-sun8i 4500000.ethernet eth0: configuring for phy/rgmii-id link mode
[   11.792129]  s11: 0000003fc739d328 t3 : 0000003fc72e2d08 t4 : c965677f28d98c6d
[   11.824305]  t5 : 0000000000000000 t6 : 611318ec7d54a35b
[   11.848138] status: 0000000200004020 badaddr: 0000003fc0000028 cause: 0000000000000007
[   11.948165] systemd[142]: unhandled signal 11 code 0x2 at 0x0000003fe938e330 in libpthread-2.33.so[3fe9387000+13000]
[   11.959545] systemd[141]: unhandled signal 11 code 0x2 at 0x0000003fe92df378 in libc-2.33.so[3fe927c000+fd000]
[   11.996127] CPU: 0 PID: 142 Comm: systemd Not tainted 5.14.0-rc4-nezha #1
[   12.003474] CPU: 0 PID: 141 Comm: systemd Not tainted 5.14.0-rc4-nezha #1
[  OK  ] Started Network Tim[   12.019165] Hardware name: Allwinner D1 NeZha (DT)
e Synchronizatio[   12.025837] Hardware name: Allwinner D1 NeZha (DT)
n.
[   12.044145] epc : 0000003fe92df378 ra : 0000003fe92df338 sp : 0000003fe912f3f0
[   12.051853] epc : 0000003fe938e330 ra : 0000003fe938e30a sp : 0000003fe892e7a0
[   12.076148]  gp : 0000002ad1589250 tp : 0000003fe9130820 t0 : 000000000000bb87
[   12.083846]  gp : 0000002ad1589250 tp : 0000003fe892f820 t0 : 000000000000bb87
[   12.104131]  t1 : 0000003fe929f7bc t2 : 0000000000004389 s0 : 0000003fe4000020
[   12.112118]  t1 : 0000003fe938ceac t2 : 0000000000004389 s0 : 0000003fe892e8e0
[   12.132148]  s1 : 0000003fe937fb00 a0 : 0000003fe4000000 a1 : 0000000000021000
[   12.144100]  s1 : 0000003fe892f49c a0 : 0000000000000000 a1 : 0000003fe892f770
[   12.164144]  a2 : 0000000000000003 a3 : 0000000000004022 a4 : 0000003fe4000870
[   12.171835]  a2 : 0000000000000000 a3 : 0000000000000008 a4 : 0000000000000000
[   12.196146]  a5 : 0000003fe4000028 a6 : 0000000000000000 a7 : fffffffffffff000
[   12.203889]  a5 : 0000000000000000 a6 : 0000003fe892f150 a7 : 0000000000000087
[   12.228150]  s2 : 0000003fe4000000 s3 : 00000000000008c8 s4 : 0000000000000006
[   12.235847]  s2 : 0000003fff9d53b6 s3 : 0000003fff9d53b7 s4 : 0000000000000000
[   12.252130]  s5 : 0000000000000000 s6 : 0000003fff9d54f0 s7 : 0000003fe95f12b0
[   12.259833]  s5 : 0000000000000006 s6 : 0000003fff9d54f0 s7 : 0000003fe892f820
[   12.284151]  s8 : 0000003fe9130080 s9 : 0000000000000000 s10: 0000003fe939f380
[   12.291879]  s8 : 0000003fe892f080 s9 : 0000000000000000 s10: 0000003fe939f380
[   12.316110]  s11: 0000003fe939b328 t3 : 0000003fe92e0d08 t4 : 0000002adfe073a0
[   12.323787]  s11: 0000003fe939b328 t3 : 0000003fe92ae6d4 t4 : 0000002adfe073a0
[   12.348141]  t5 : 0000002adfde2c60 t6 : 0000000002adfe07
[   12.353904]  t5 : 0000002adfde2c60 t6 : 0000000002adfe07
[   12.368140] status: 0000000200004020 badaddr: 0000003fe4000028 cause: 0000000000000007
[   12.376530] status: 0000000200004020 badaddr: 0000003fe892f49c cause: 0000000000000007
[   12.400371] Kernel panic - not syncing: Attempted to kill init! exitcode=0x0000000b
[   12.408037] CPU: 0 PID: 1 Comm: systemd Not tainted 5.14.0-rc4-nezha #1
[   12.414650] Hardware name: Allwinner D1 NeZha (DT)
[   12.419435] Call Trace:
[   12.421882] [<ffffffff80003df0>] walk_stackframe+0x0/0xc8
[   12.427297] [<ffffffff805bc364>] panic+0x128/0x314
[   12.432100] [<ffffffff8000e490>] do_exit+0x888/0x900
[   12.437072] [<ffffffff800db5d8>] kmem_cache_free.part.0+0x1a4/0x390
[   12.443355] [<ffffffff8000e578>] do_group_exit+0x30/0xc0
[   12.448672] [<ffffffff80019c2c>] get_signal+0x1c4/0x838
[   12.453903] [<ffffffff80003168>] do_notify_resume+0x78/0x418
[   12.459568] [<ffffffff80002118>] ret_from_syscall_rejected+0x8/0xc
[   12.465766] ---[ end Kernel panic - not syncing: Attempted to kill init! exitcode=0x0000000b ]---

13.11.2021

All code, for now, is at the develop branch. At this moment build process passes but the image not running at the board.

u-boot can't uncompress the fitImage:

Error: inflate() returned -5
gzip compressed: uncompress error -1

Cezarus27 / meta-nezha

readme