A Home Assistant custom Integration for local handling of Devices connected to Rademacher bridge.
Works exclusively when devices are connected through HomePilot or Start2Smart Bridge.
Bridges/Gateways from Rademacher are fully supported.
See full device list support at the end.
Scenes will be automatically added as Home Assistant Scenes with "Homepilot" prefix. These scenes can be executed as any other Home Assistant Scene but cannot be edited.
HACS is a community store for integrations, Frontend extensions, etc. It makes installation and maintenance of this component much easier. You can find instructions on how to install HACS here.
Navigate to HACS in you Home Assistants Interface.
Click "Explore & Download Repositories"
Search for "Rademacher Homepilot Bridge"
Click "Download this Repository with HACS".
Select the version you wish do download and finally click "Download".
Restart Home Assistant.
Copy the rademacher
folder into yout Home Assistant's custom_components
folder.
This should be located under the /config
folder.
If you haven't done it already, you should create the custom_components
folder on your /config
.
Restart Home Assistant.
First of all, you should add the devices in you Home Pilot Application, or in the Bridge's Interface. The integration works by fetching the list that is registered in the Hub.
When Home Assistant Core is running on the same sub-network as the Hub, if auto-discovery works, you'll see a notification on HA GUI stating it found new devices.
Just click "Check it Out" and you'll be presented with the Integrations page where you should see the new Rademacher Bridge entry.
Click "Configure". If you have set a password for the Hub, enter it and press "Submit".
On the next dialog, Choose any device that you may want to exclude from managing in HA. If you want to manage all, just press "Submit".
You should now be presented with Device/Entities detected, you should select the HA Area where you want to add them.
If Hub has not been auto-discovered, or you just deleted the integration and want to add again:
Start by going to Configuration > Integrations, then press the "Add Integration" button.
Then, search for Rademacher and select it.
In the Dialog that appears, insert the HostName/IP Address of the Rademacher Bridge. Ex: bridge.local
or 192.168.1.60
Press "Submit".
If you have configured a password for the hub, you'll be asked for it. Just insert it and press "Submit".
On the next dialog, Choose any device that you may want to exclude from managing in HA. If you want to manage all, just press "Submit".
You should now be presented with Device/Entities detected, you should select the HA Area where you want to add them.
Pedro Ribeiro |
Michel Munzert |
David Girón |
Misa1515 |
der-berni |
Thmnxo4 |
Mrweidenmr |
The integration should work with the following devices (tested devices are marked in bold )