-
My house came with one of these disused and sitting in the corner. I looked through the documentation and it seems like the it's programable in some fashion to trigger behaviors when audio is sensed o…
-
Hi,
First of all, thank you for your work!
I tried tonight to solder wires to the TX/RX pads, tripped, and ripped off the conductive layer on the TX1 pad; I tried recovering by scraping off a bi…
-
We encountered a power supply issue when using the Bolt device. The details are as follows:
Power Setup:
The Bolt is connected to a computer via USB. If the USB power supply is insufficient, the…
-
I wanted to report that with some minor changes to BaseClient.py I was able to get the new Pro series batteries from Renogy working.
Added:
ALIAS_PREFIX2 = 'RNGRBP'
and changed the line
…
-
Hey guys,
On the board i have the 12V output connector that is not working.
I have connected it to a 12V consumer and noticed nothing was happening, when i fluked the wires i saw that there is …
-
I'm unable to process my WireViz file. It's correctly formatted, but it fails with a strange error. To reproduce, save the harness.yaml file in the same directory that command will be run from, and th…
-
It seems that my Kasli-SOC was short circuit and the fan doesn't work. The chip `LTM4644IY` is a little hot.
![image](https://github.com/sinara-hw/Kasli-SOC/assets/42793494/7b822b12-ec6f-42f7-b958…
-
Hi, I've been using a previous version of this code with some tweaks but on separate USB channels. I've installed this new version without too many issues for a single battery but I'm a bit confused w…
-
I'm not sure how or if we would do this but I think it would be useful info to report on, especially since nothing will work if it's off.
-
I have a revGboot looping if powered from 12V, but works fine if first powered by 5v.
I have tride Full DFU Erase and reloading firmware, but not improvement