-
Hi Murray!
I am encountering an issue when trying to create a multi-session model using the openCR.fit function. The code runs without errors when using secr.fit, but it fails with openCR.fit, even…
-
Hello. I designed a robot with OpenCR that contains dynamixel pro. Would like to further control OpenCR and the robot through Xavier NX as a master controller. In the video I saw online it mentioned *…
-
Hi Murray,
I have a question about this line:
https://github.com/MurrayEfford/openCR/blob/366927414633c83158034bef3e7f63e99922449f/R/openCR.fit.R#L140
Is `tail(details$agebreaks,2)[1]` meant …
-
```secr``` installs OK on macOS Sonoma 14.5 and R 4.4.1 (all the latest). BUT on arch = x86_64 (Intel)
Then on ```require(secr)``` it just segfaults:
... OK, so package was successfully install…
-
- [ ] ISSUE TEMPLATE ver. 0.4.0
1. Which TurtleBot3 platform do you use?
- [ ] Waffle Pi
2. Which ROS is working with TurtleBot3?
- [ ] ROS 2 Humble
3. Which SBC(Single Board Co…
-
Turtlebot3: Open Manipulator: bringup fails: ERROR from Dynamixels SDKWrapper : No status packet found + proces dies: stack smashing detected.
- Ros 2 Humble
- Raspberry Pi 4
- Ubuntu 22.04
- O…
-
ISSUE TEMPLATE ver. 0.4.0
1. Which TurtleBot3 platform do you use?
- [ ] Burger
- [ ] Waffle
- [v] Waffle Pi
2. Which ROS is working with TurtleBot3?
- [ ] ROS 1 Kinetic …
-
@ROBOTIS-David @ROBOTIS-Will @ROBOTIS-Kayman How can I adjust the frequency of CAN communication in OpenCR1.0 using the Arduino library?
-
hello,
I am currently trying to do the steps for the OpenCR Hardware Setup for the OpenMANIPULATOR-X for the OpenCR board on Ubuntu 16.04. But when I run the first two "wget" links on the terminal …
-
Hello...
My name is Chris from Indonesia.
I would like to ask is it possible to use RS 485 port in openCR 1.0 board to control another device beside dynamixel. I have BLDC motor controller need to b…