-
Hi there, I'm exploring what you guys did with this reverse engineering, it's really great, thank you.
I managed to communicate with my Supramatic E3, and I am now able to open/close my garage door t…
-
I found your code very useful and adjusted colors to darkmode. You can use these changes in your library
```
html.light {
--blue: #1890ff;
--blue-border: #0076e4;
--light-gray: #bfcbd9;…
-
the flysky fsi6 works, but the switches dont really work. the first switch is triggered when the joystick moves and you cannot set the potentiometers so servos dont work well since they are constantly…
nqwoq updated
3 weeks ago
-
We have RCP design where host and radio controller communicated over SPI through spinel interface.
We have observed, Frame pending bit set to 1 in ACK of reply received from end-device.
During …
-
### The problem
I am a new user of Home Assistant and have installed HomeAssistant in a Proxmox VM which has been working well for a little while. I have added a SMLight SLZB-07 USB adaptor to expri…
-
Having bought a cheap controller that did not work, I discovered that they behave as if they are wired USB controllers with a simple radio in between. Thus it does not work the same way, but with simp…
-
## Current Behavior
When I setup a button in modes to enable the beeper from my radio, it does not work in INAV but with the same quad if I load Betaflight the beeper does indeed work. So I know …
-
There needs to be a radio flight controller purchased and setup with the S500 hexacopter drone. Furthermore, proper installation must be investigated.
-
Radio controller starts .wav recording when pass begins, but doesn't end the recording afterwards. Problem occurs in SDR++ and GQRS
-
It's not possible to emulate Analog trigger values.
As you can see in the Wine Control Panel screenshot bellow, User 0 is the emulated device by SC Controller and the User 1 is the direct output of…