-
I want to install the firmware to my 3D printer
-
Encoder sensitivity is not ideal.
According to http://www.rf1000.de/viewtopic.php?p=18869#p18869
- Pulses_Per_Unit = 3
- Step_Per_Unit = 1
would be ideal.
-
According to http://www.rf1000.de/viewtopic.php?f=89&t=1827&start=20 these may be missing in the source code since Conrad "gets only the compiled file". This would be a clear GPL violation.
-
@RF1000
RAMPS servo pin definition in configuration.h overwrites other servo pin definitions made in pins.h
Not checked but I guess affects also V0.91.59
-
Hello!
Rf1.37 Do not build with arduino 1.6.12 But it does with arduino 1.0.6
Here is the build log from 1.6.12
Arduino: 1.6.12 (FreeBSD), Board: "Arduino/Genuino Mega or Mega 2560, ATmega2560 …
-
### Version
2.4.0 beta1 win64 (and **presumably earlier versions**)
### Operating system type + version
Windows 8.1
### 3D printer brand / version + firmware version (if known)
Printer:…
-
Homing z in milling mode leaves lower z switch pressed. When switching to printer mode, any attempt to move z upwards fails because of the pressed switch. Homing will then drive the z axis to a crash …
-
When switching the mode in the menu the z-endstops are not recognized. Reaction is normal after reset.
-
I have huge problems with RF2000.
From time to time the LCD is going completely blank.
I have had over 20 problems with auto leveling, where the leveling was not completed . turning on and off the …
-
Hello there :)
We dont want to keep our findings a secret. Thatwhy I post this here:
Playing with the PID control did improve a lot in my firmware. But the heated beds where not perfect. So we tri…