-
I'm interested in adding support for the new AVR chips, 0/1/2-series tinyAVR and megaAVR, that have been released in the past few years. While overall the cores look a lot like classic AVR cores, ther…
-
The tinyAVR 0/1 series are supported by avr-libc (development version, no release yet), thus the "proprietary" Atmel DFP isn't necessary.
In the past one was able to fake its existence by setting a…
-
This library will provide the following functionality:
* Allow sleep where the RTC is used to keep time in standby sleep, and adjust millis() time upon wake, when using any timer except RTC as the …
-
Maybe not an issue, but why do you do this?
```
/* Enable all UPDI port pull-ups */
PORT(UPDI_PORT) = 0xFF;
```
```
/* Enable all LED port pull-ups, except for the…
-
I'd love to see the ability to program the fuses for the relatively new tinyAVR 0/1/2 and Atmega series (like mega3208/09, mega4808/09, AVR128DBxx. I use AVRDUDESS regularly for "mass" flashing (haha,…
-
Hi,
I am having quite a trouble figuring out how to compile the HV firmware from source. I tried following your custom toolchain, which finishes succesfully, however when I try to use:
`make -f Mak…
-
Hello,
Is possible to support the attiny1614 more (ram/flash) ?
I get errors in make because the "USB_INTR_PENDING_BIT":
sbdrv/asmcommon.inc: Assembler messages:
usbdrv/asmcommon.inc:99: Error:…
-
Hi,
I can Flash and read the FUSEs but when I try to set a fuse it always fail with the error below.
```
ze-mac:device ze$ pyupdi.py -fs 0:0x00 -c /dev/cu.SLAB_USBtoUART -d tiny202 -b 115200
Dev…
-
Hey there, after suffering from a severe case of NIH I've decided to write some assembly for the ATtiny1614: https://www.microchip.com/wwwproducts/en/ATTINY1614
It's not directly listed in avra's d…
-
1. The recording address of SIGROW_DEVICEID[012] is different for AVR_EA and AVR_EB. Therefore, you need to create separate binaries for each.
2. CLKCTRL of AVR_Ex is equivalent to tinyAVR/megaAVR se…