-
Hi,
Thank you for this amazing project! I truly appreciate all the hard work and dedication put into it.
I would like to inquire if there are any plans to support the TTGO Watch product lines. T…
-
Hello,
Is it possible to add support for TTGO T-Internet?
https://www.tindie.com/products/lora-aprs/lora-on-poe-esp32-board/
Here is a version that supports it:
https://github.com/lora-aprs/Lo…
f4dvk updated
1 month ago
-
TTGO_TWatch_Library-master\src\drive\tft\ bl.h
...
In file included from c:\Users\Lenovo\Documents\Arduino\libraries\TTGO_TWatch_Library\src/TTGO.h:105,
from c:\Users\Lenovo\Docume…
-
I have a ttgo lora 32 v1 from 868-915 mhz, what frequency do you recommend to use?
-
Good morning
Your program "Temperature example" is presented as possible on ESP32+ module sx12xx.
But the "platformIO" of this github is specified as suitable for a "ttgo-lora-v1".
Is it the same t…
-
Hi, I'm trying to attach a BME280 sensor to my Lilygo TTGO LoRa T3-S3 that I just bought, but the pinout on the site is not correct.
![H594-PIN-DIAGRAM_600x600](https://github.com/LilyGO/TTGO-LORA32/…
-
It would be a great upgrade from the T-display which is supported to this one. The ESP32 S3 is supported in the later version of esptool which I don't believe brewflasher is using yet.
-
I bought a few TTGO T-Display v1.1 modules awhile back and put them in a drawer. When I exhausted my supply of the older boards, I discovered that I couldn't communicate with the newer boards. Debia…
-
Hi all,
there is an issue when power failure occurs. rdz_ttgo_sonde boots faster than WiFi router after Power ON and it doesn´t connect to the WiFi. rdz_ttgo_sonde switches to the AP mode in this c…
-
Hello,
i am unable to compile version 3.6.2 for heltec esp32-s3 v3.1 hardware. I try all 3 possible options in platfomio.ini
halfile = ttgotdongles3.h
;halfile = ttgotdongledisplays3.h
;halfi…