-
@tridge , I wanted to thank you for improving AP so that RTL could be more reliable as a "oh crap" switch to recover from unexpected situations/pilot loss of control. Unfortunately it almost failed me…
-
I am having a problem with Fail Safe using INAV. I have setup a switch to test Fail Safe but if I activate it the craft just falls out of the sky.
In INAV Fail Safe stage 2 is enabled,
Fail Safe …
-
Fresh Inav 1.7.0 on genuine Omnibus F4 v3.
`# dump
# version
# INAV/OMNIBUSF4 1.7.0 May 3 2017 / 11:22:34 (104b66c)
# resources
# mixer
mixer QUADX
mmix reset
# servo
servo 0 1…
-
I discovered a weird dependency between connecting/enabling of an external mag (HMC5883) and functionality of my gimbal on SPRacingF3 (Acro) board. The gimbal works fine if the mag is either disconnec…
-
From command in the CI build (https://ci.vmware.run/vmware/vic/6919):
```
docker -H dhcp-192-168-31-152.ci.drone.local:2376 --tls ps -aq | xargs -n1 docker -H dhcp-192-168-31-152.ci.drone.local:2376…
-
i'm using flying wing mode.
while i armed motor, and put angle mode, when push motor stick ( above 1100) left or right aileron moves slow to max up/down.
when throttle stick moves down, to stop. ail…
-
I recently damaged my original UBLOX gps and had a NAZA GPS clone laying around so I thought I would use that instead. I have built the firmware for my Naze32 Rev6 to include the NAZA protocol. I seem…
-
Pitch + throttle are correct, but maybe they didn't need to be reversed.
QGC + PX4 master
dagar updated
7 years ago
-
On spracingf3 the current detected by the virtual sensor is multiplied by 10, on standby should bring 320mA but instead shows 3.2A
-
When setting up a new fw I noticed that there is no acro mode for airplanes according to the [docs](http://dev.px4.io/concept-flight-modes.html).
Is this correct? And in that case how much work wou…