-
Hello!
I have a question:
My vehicle is a flying wing. So in your documentation, the setpoints can only be set with x,y,z,yaw. Can't I control the pitch and roll angle?
Thank you!!
-
![image](https://user-images.githubusercontent.com/36
![1600fe6b826eea4c8a348cd54ded86a](https://user-images.githubusercontent.com/36288561/48465768-e301a980-e81e-11e8-9d0c-ae202fe70e38.jpg)
![49b…
-
## Describe the bug
I am trying to setup my environment for HITL with pixhawk 5x/pixhawk 2 cube/pixhawk 1. Upon uploading the firmware (v1.13.0), QGC gives the error of missing parameters: "Parameter…
-
### Describe the bug
I am connecting _two_ [LIDAR-Lite V3](https://www.garmin.com/en-US/p/557294) sensors on the I2C port of Pixhawk 6C using the [I2C Splitter](https://www.amazon.com/Pixhawk-i2c-Spl…
-
## Expected Behavior
Compass Calibration fitness parameter's range is 4 ~ 32.
## Current Behavior
Compass Calibration fitness parameter is set 100 in compass calibration.
## System Information…
-
To get frsky X series telemetry from a flight controller to a handset I use a mavlink-frsky converter normally used on a pixhawk>X8R setup to get telemetry down via smartport but I use it connected di…
-
https://github.com/marketplace/imgbot
@mhkabir Thanks for link above. I'm in two minds about automating image compression. Obviously smaller files makes things better for end users. My concern is …
-
**Describe the bug**
When using a Pixhawk 2.1 flight controller, QGroundControl complains about an inconsistency in the incoming magnetometer data. It turns out that the way to satisfy QGC (and PX4) i…
-
Currently, when you read the guide, it is very focused on the solo itself whereas the system
is essentially comprised of two fairly different devices.
First, it is at times unclear whether the instru…
ghost updated
8 years ago
-
## Describe the bug
I'm currently using PX4 Firmware v1.13.1, tested with different flight controllers (CubePilot CubeOrange and Pixhawk 4). I have set the SENS_EN_LL40LS to I2C and SENS_EN_IRLOCK to…