-
I think the seeed would support it, but could the firmware be updated to support a magnetometer for better pan support? I think we would also need some kind of configuration options for defining which…
-
https://www.figma.com/design/R0fesrDQcX4lujNMnAT5su/Untitled?node-id=0-1&t=mctmG04ecXBsFUYS-1
-
I've done several attempts to calibrate MPU6050 / 9250 with an Arduino Due and it never reaches the end. Code works fine with Mega 2560 though.
Could you please help me with the Arduino Due?
Do…
-
my hardware is naze32, In angle mode, before fly ,I have do accelerometer calibration, in few minutes ,the roll and pitch will drift. what is matter? I've been testing it for a week, and it's all like…
-
When the SPI interface is chosen (P1), the accelerometer data (at least the Z-axis) reads slightly differently than when I2C is chosen. The Z-axis reading should be approx. 1g when the chip package to…
-
Calculated orientation drifts off too easily. A possible cause might be that we don't have any calibration process for the sensors.
From the WAX9 developers guide:
```
The linearity, offset and nois…
araid updated
9 years ago
-
a) When and how will be haptics supported in SDKs?
b) How are quaternions in Kai computed? What are they useful for? Is it just combination of the 3 sensors (accelerometer, magnetometer, gyroscope)…
-
How to calibrate compass and accelerometer ?
What are those values refer to?
#Calibration
calib:
compass_min: [-28.451460, -42.645390, -38.086895]
compass_max: [68.179794, 48.143326, 57.7…
-
Hello @RCmags
I am rewriting the code to assemble it under the `stm32f411ceu6` or [BlackPill](https://stm32-base.org/boards/STM32F411CEU6-WeAct-Black-Pill-V2.0.html) in the `Arduino` ecosystem.
![s…
-
I am using megapirateng 3.0.1R4..and I am using HK RED multiwii board .
I am able to calibrate the accelerometer...though I am following the same steps as given by MP.
I tried it many times but its al…